clutch cable routing (2020)

Joined
Feb 21, 2019
Messages
1,067
Country flag
a while ago, someone posted some sort of factory sketch or drawing on how the clutch cable routes through the frame. can't seem to find it through the search function, so can anyone repost? TIA
 
a while ago, someone posted some sort of factory sketch or drawing on how the clutch cable routes through the frame. can't seem to find it through the search function, so can anyone repost? TIA

Check this post:
 
Factory service release.

clutch cable routing (2020)
 
The INOA pic posted above by Steve is how I do it. So long as you’re careful when fitting the tank, no cable ties are needed, just ensure the cable is sitting above the front tank support and is not trapped as you lower the tank. With the tank in place, the cable can’t go anywhere, but is free to flex giving a nice lever action.

A loose cable tie, as suggested by Steve, may help tank with tank fitting if needed. But I believe the most important thing to remember with clutch cable routing (on virtually any bike) is to totally avoid the use of tight cable ties anywhere on the cable.
 
That is the clutch cable routing documented in the INOA tech digest. As a contributing editor, I happen to be the guy who submitted the drawing. While I do note the factory routing and the cable was installed in the factory way on my 5 mile never registered MKIII, I would NEVER run a bike like that.
Yes one tie wrap only, holds the cable only, do not include the wiring .this method works for fastback-central and roadster oil tanks.
 
Last edited:
That is the clutch cable routing documented in the INOA tech digest. As a contributing editor, I happen to be the guy who submitted the drawing. While I do note the factory routing and the cable was installed in the factory way on my 5 mile never registered MKIII, I would NEVER run a bike like that.
Yes one tie wrap only, holds the cable only, do not include the wiring .this method works for fastback-central and roadster oil tanks.

I can personally vouch for this routing: I just installed a new Venhill cable on my bike a few weeks ago, and it was like the cable wanted to follow this path. A bit of Fluid Film for lube, and instant 1.5 finger clutch.
 
clutch cable routing (2020)
clutch cable routing (2020)
clutch cable routing (2020)
clutch cable routing (2020)
 

Attachments

  • clutch cable routing (2020)
    AA2162C5-2C67-4F47-A8CC-BF20BE9AFCF5.jpeg
    383.4 KB · Views: 66
At the front, I have the clutch & throttle/choke cables loosely tied together just enough to hold them in off the tank. NOT tied to the frame there.
clutch cable routing (2020)
 
Last edited:
So if I'm looking at the picture correctly the cable goes to the rear of the battery box brace and over the top of the air cleaner back plate?
 
You also went through the wiring grommet?
Yes.

Disclaimer: this is where my Venhill was most happy, the bends being gentle, the entry into the gearbox at the best angle. Some cables of different lengths may not be able to be routed this way.

JMWO
 
Back
Top