Guys, just spent a frustrating day trying to fit my new CNW hydraulic clutch. Everything fitted as per the instruction sheets, went smooth as silk. That is till I tried to fit female fitting on the braided hydraulic line to the 3AN male fitting protruding from the tranny cover. GGRRRRR!!!! The braided line can not be fitted to the tranny fitting, regardless where the tranny is adjusted to. The reinforced section behind the female swivel fitting is too long and the line strikes the top iso tube. I even adjusted the tranny as far forward as it could go just to see if the line could be fitted, but it cant be, the iso mount tube still interferes with it. You can just get the fittings done up but there is a troubling bend in the line and adjusting the tranny is out of the question.
In my case I have ordered a male/female 45 deg adaptor fitting from earl's supplier here in Australia but it cost me $40 inc shipping.
Pissed off? You bet. Just be aware these are not just a bolt up proporsition. (in some cases there may be some fettling)
:cry: ( Not pissed at MATT or CNW, pissed that things didnt go the way I wanted)
JUG
In my case I have ordered a male/female 45 deg adaptor fitting from earl's supplier here in Australia but it cost me $40 inc shipping.
Pissed off? You bet. Just be aware these are not just a bolt up proporsition. (in some cases there may be some fettling)
:cry: ( Not pissed at MATT or CNW, pissed that things didnt go the way I wanted)
JUG