Recommissioned CNW 012

[gortnipper]

No Matt does not I was speaking with him about the board they used to use for the beehive lamp
The CO bulbsthatlastforever.com
Is long gone.

Yes, BritCycle took over them

L679 And L917 Taillight LED Conversion Kits

britcycle.com

 

[olympus]

Yes, BritCycle took over them

L679 And L917 Taillight LED Conversion Kits

britcycle.com

Many thanks for this info. i will order one up today

 

[zefer]

Yes I stand corrected. I just found their website and I saw the kits. I think I will try it on another lamp set up i have

 

[zefer]

This is the body work and paint that I am settled on. I finished polishing all the brite work…hats off to Matt…it is alot of work !
I could only hope to get close to his level of finish. I did the gearbox fluid..enine oil and filter
New plugs and wires fresh peg and shifter rubber. I am going over the tank with clay,compound and finish with a nice carnuba wax. I will have no problem getting this bike dirty so long as it starts off clean. I have thoroughly
Enjoyed the rebonding and it now looks and runs like it was meant to be

 

[Fast Eddie]

Congrats dude. A stunner. Some zip ties around the top of those fork gaters and you’re good to go!

 

[YING]

Congrats dude. A stunner. Some zip ties around the top of those fork gaters and you’re good to go!

Nigel,
An old solution for no zip-ties is to wrap some electrical tape around the fork tubes about an 1/4-1/2” below the lower clamp enough to build it up enough to slide the boots over and hold them in place. I have done this quite a few times with good results.
Mike

 

[Fast Eddie]

Nigel,
An old solution for no zip-ties is to wrap some electrical tape around the fork tubes about an 1/4-1/2” below the lower clamp enough to build it up enough to slide the boots over and hold them in place. I have done this quite a few times with good results.
Mike

I’ve never heard of that one Mike. I’ll put that in my ‘experience pot’ for future use !

 

[DennisMo]

Nice baseball Cap on top of the Headlight!

 

[ashman]

I first used zip ties on the garters, worked great but I just ended up buying the right clips from RGM SS look a lot better and they didn't cost that much when I got some other parts.

 

[MichaelB]

Nigel,
An old solution for no zip-ties is to wrap some electrical tape around the fork tubes about an 1/4-1/2” below the lower clamp enough to build it up enough to slide the boots over and hold them in place. I have done this quite a few times with good results.
Mike

So simple and Brilliant!!