To Fastback - Boyer Powerbox - battery setup

Status
Not open for further replies.

Jerry Doe

Admin
Joined
May 21, 2003
Messages
2,223
Hi Phil and anyone else,

I am just about to wire in a boyer power box along with my boyer ignition. I was reveiwing the swingarm spindle post and noticed you have a powerbox and small battery.

For me this is a first and I am not sure if I should use a small battery along with the powerbox or go without a battery. I only plan on riding the Commando every few weeks or once a month so would prefer without battery.

I have been told ignition, low rev running and starting are fine without a battery, but find that hard to believe with boyer ignition. I dont use the lights much.

What size and type of battery are you using? Have you ever tried running without the battery?

Best Regards,

Jerry
 
Hi Jerry,

I haven't tried running without the battery, I was wondering if I could skip the battery with the Sparks alt. when I did my setup. At the time the forum's collective wisdom, and especially Dyno Daves analysis on the Boyer needing a minimum voltage of 10.8vdc to operate reliably, convinced me to just shell out $14 for the sealed cell. 12volt 3amp

Dave's info is here http://atlanticgreen.com/boyerevolved.htm.

I have the first stop on my ignition switch set to just ignition for starting or serious idling. The 55/65 H4 Halogen will drain that little battery pretty quick without a charge on the other end.

Here's the battery: http://catalog.digikey.com/scripts/partsearch.dll?Detail?name=522-1009-ND
I hope that helps.

Phil
 
I have a '70 Fastback that I installed a Boyer onto back around 1997. All the rest of the electrics are original OEM, i.e., RM 21, Lucas rectifier, Lucas zener, and "blue can" cap. One day a few years ago I was driving down the inerstate & noticed that my ammeter (in headlight) was showing no charge; normally it will register above 0 when the engine is running. But the bike was running right & everything else seemed ok, so I kept on going. When I exited the highway all was fine - engine idled fine, but when I pulled on the front brake to hold the bike on the uphill exit ramp, the bike died. I was able to kick it back to life easily and made it home. Long story short I finally discovered that my fuse was blown due to the insulation on the front brake cable switch being worn through & it was shorting out on the lower triple clamp, blowing the fuse. It must have been the output side of the switch that was shorting because the bike would start & run fine unless I pulled the front brake, and only at idle.

The point is that my alternator put out enough current & voltage to operate my Boyer without a battery, even for start-up. I think if your blue can is ok, a couple kicks prior to turning on the switch is enough to charge up the cap & fire your Boyer.

I don't have any technical data to back this up, just my own experience. Might be interesting to see if your bike will start with the batterry disconnected.
 
Status
Not open for further replies.
Back
Top