I have just separated my cases on am 1974 850 Interstate. The main bearings are FAG NU306E Does anyone know if these are the original Superblend Bearings? Also what is the best method to pull the bearings off the crank not much room to get a puller in there. Would heating with a propane torch losen them up or will that damage the case hardening? Bike had 13000 miles on it .Also had the crank apart and cleaned it up should I put Loctite on the nuts? manuals say tighten very very tight? but no torque setting? Any ideas on what the torque setting might be. Enjoy this forum very much lots of great ideas
Thanks Drummer99
Thanks Drummer99