MK3 Crankshaft seal

hillbone · Feb 19, 2012

Hi.

I read on some earlier posts about an all rubber cranshaft seal for the primary case. Has anyone the dimensions so I can order one please?

Cheers Hillbone.

pelican · Feb 20, 2012

they are on steve maney's site
www.stevemaney.com/products.html

pommie john · Feb 20, 2012

You can get them from any bearing shop for half the price.
I can measure mine tomorrow if no one has chimed in before then.

From memory ( and that's not too reliable) it's 1.125" X 1.75" X 0.25"

bill · Feb 20, 2012

the ones i have are HARWAL brand and marked 1.188 x 1.750 x .250

pommie john · Feb 20, 2012

bill said:
the ones i have are HARWAL brand and marked 1.188 x 1.750 x .250

Interesting.
1.188" is 30mm which is correct for the crank, but the OD and depth are imperial measurements.

Mine are marked as I remembered 1.125x 1.75 x .25

The ID ( inch and an eighth) is only 6 thou tighter than the metric ID

dynodave · Feb 21, 2012

pommie john said:
bill said:

the ones i have are HARWAL brand and marked 1.188 x 1.750 x .250

Click to expand...

Interesting.
1.188" is 30mm which is correct for the crank, but the OD and depth are imperial measurements.

Mine are marked as I remembered 1.125x 1.75 x .25

The ID ( inch and an eighth) is only 6 thou tighter than the metric ID

1.188" - 1.125" = .063" or 63 thou

pommie john · Feb 21, 2012

dynodave said:
[

1.188" - 1.125" = .063" or 63 thou

Yep, you;re right. A bit of brain fade on my part.

I'm pretty sure the genuine seal is 1.125" ID running on a 30mm shaft. Anyone care to confirm?

bill · Feb 22, 2012

OK 30 MM converts to 1.181099

pommie john said:
Yep, you;re right. A bit of brain fade on my part.

I'm pretty sure the genuine seal is 1.125" ID running on a 30mm shaft. Anyone care to confirm?

pete.v · Feb 22, 2012

That make sence on the id but I think the width is .1875 ( 3/16").

hillbone · Feb 22, 2012

Thanks everybody. I have the new seal ready to go. Regards Hillbone

MK3 Crankshaft seal

Similar threads