I'm getting ready to install my new left side adjuster (Thanks bpatton!) and want to make sure I have it assembled correctly and that I understand what I'm doing. I've looked at highdesert's photos, but his adjuster is a little different from mine. Assuming the top of my photo is the front of the bike, is this the correct orientation? Does it matter if the adjuster that is captured to the bolt (the left side in this photo) is on the left or right? I assume I want to keep the large nut on the right side so it's easy to get to.
Currently my belt is tracking straight. If I leave the gearbox lower nuts tight, will the gearbox stay in position while I change out the top adjuster bolt? If not, what is the procedure to correctly adjust the belt tension and tracking? Will spinning the back wheel prove that the belt tracks true?
Currently my belt is tracking straight. If I leave the gearbox lower nuts tight, will the gearbox stay in position while I change out the top adjuster bolt? If not, what is the procedure to correctly adjust the belt tension and tracking? Will spinning the back wheel prove that the belt tracks true?