Heinz Kegler's Swingarm Rings

Hi , thank you Hobot, for your answer, could be nice but shipping cost will kill the saving!!! about the sizes , I will guess ,the I.D is easy to sort out (28 or 29mm , yes sorry not speaking inches....) the width will be around 1 ", that was the O.D , I have to estimate , taking in count I need to drill/tap, two 8mm (or 5/16 ") holes, allowing enough meat , so it should be something like 70 or 80 mm,for the O.D, the problem could be the clearance with the oil filter , will see this week end with my friend the turner ..................try to find some alloy round bar in 80mm this afternoon , but no way, so tomorrow will go to pick up some steel, heavier an rust prone , but.........many thanks .

Oh ok, don't know where ya at and more efficient for me to just take some measures if others or the vendor spect don't reveal it already. There is at least three ways to skin this spindle trapping cat. Info over load helps stretch the ole neurons crust off and what else is as interesting in pay back. May your spindle Live long and prosper.