- Joined
- Nov 4, 2007
- Messages
- 1,365
Hi , thank you Hobot, for your answer, could be nice but shipping cost will kill the saving!!! about the sizes , I will guess ,the I.D is easy to sort out (28 or 29mm , yes sorry not speaking inches....) the width will be around 1 ", that was the O.D , I have to estimate , taking in count I need to drill/tap, two 8mm (or 5/16 ") holes, allowing enough meat , so it should be something like 70 or 80 mm,for the O.D, the problem could be the clearance with the oil filter , will see this week end with my friend the turner ..................try to find some alloy round bar in 80mm this afternoon , but no way, so tomorrow will go to pick up some steel, heavier an rust prone , but.........many thanks .