961 specialist/ mechanic Alberta Canada needed!

CoryDee · Jun 10, 2025

TonyA said:
Get a Bosch cam position sensor , a TPS , 2 fuel injectors , and get these installed. Try this and report back.

Do you happen to know the link for the list of part numbers?

Stephen_Spencer · Jun 11, 2025

Alternate Parts List - Resources menu above. Good luck

.

This is an alternate parts list for the Modern Norton Commando. Click here to review.
https://www.accessnorton.com/resources/961-norton-alternate-parts.7/

TonyA · Jun 11, 2025

Stephen_Spencer said:
Alternate Parts List - Resources menu above. Good luck.

This is an alternate parts list for the Modern Norton Commando. Click here to review.
https://www.accessnorton.com/resources/961-norton-alternate-parts.7/

Thanks for providing this.

TonyA · Jun 11, 2025

TonyA said:
Get a Bosch cam position sensor , a TPS , 2 fuel injectors , and get these installed. Try this and report back.

While you have the fuel rail off , give it a good cleaning inside.

CoryDee · Monday at 6:03 PM

TonyA said:
Get a Bosch cam position sensor , a TPS , 2 fuel injectors , and get these installed. Try this and report back.

Did all of that. No difference.

Checked wiring from cam position sensor to ECM all the wires check out.

Bike starts. Gets to temp and then stalls out

TonyA · Tuesday at 4:21 AM

CoryDee said:
Did all of that. No difference.

Checked wiring from cam position sensor to ECM all the wires check out.

Bike starts. Gets to temp and then stalls out

When it happens have you determined what is missing spark or fuel ? Could you have a heat sensitive ignition coil or maybe a crankshaft timing pickup coil ?

speirmoor · Tuesday at 7:18 AM

Do you still have electrical power when the engine stalls ?

TonyA · Tuesday at 8:18 AM

speirmoor said:
Do you still have electrical power when the engine stalls ?

Good question . Is it still running the same exact way , not any better ?

CoryDee · Tuesday at 8:43 AM

speirmoor said:
Do you still have electrical power when the engine stalls ?

Yes we still have electrical work it stalls

CoryDee · Tuesday at 8:44 AM

TonyA said:
Good question . Is it still running the same exact way , not any better ?

It then doesn’t seem to want to restart. The issues also seem to miserly flare up with it gets up to temp

TonyA · Tuesday at 9:09 AM

CoryDee said:
It then doesn’t seem to want to restart. The issues also seem to miserly flare up with it gets up to temp

You can ohm out the crankshaft pickup coil. Around 500 ohms . If it is drastically different value , consider replacing it. These are available from a few different sources .

TonyA · Tuesday at 9:11 AM

TonyA said:
You can ohm out the crankshaft pickup coil. Around 500 ohms . If it is drastically different value , consider replacing it. These are available from a few different sources .

You can also ohm check the ignition coil. The prices for these parts are reasonable.

TonyA · Tuesday at 9:15 AM

TonyA said:
You can also ohm check the ignition coil. The prices for these parts are reasonable.

The tip over sensor can be jumped out also. You need to provide a low to the ecu input , there is a thread in this .

961 specialist/ mechanic Alberta Canada needed!

Similar threads