- Joined
- Dec 28, 2008
- Messages
- 2,035
I started out with beam types, went to clickers and now have an electronic torque wrench, which I have lost trust in and 'am not interested in paying for a calibration study. I did have my clickers calibrated (Sears brand) after many years of use; the cal lab is close by. I was amazed at how accurate they were; I wanted them to be "on the money" for a Mk III engine I was going through.
The electronic wrench I have is branded as an Eastwood, it wasn't the least expensive, but considerably less than what's out there, and I did a lot of digging before placing the order.
Anyway, I could use any recommendations you members may care to share about what type and what brand you use and trust. This time I will purchase based on reputation and leave cost out of the equation.
Many thanks.
The electronic wrench I have is branded as an Eastwood, it wasn't the least expensive, but considerably less than what's out there, and I did a lot of digging before placing the order.
Anyway, I could use any recommendations you members may care to share about what type and what brand you use and trust. This time I will purchase based on reputation and leave cost out of the equation.
Many thanks.