I packed extra washers between the nut and Z plate so as you tighten the nut it pulls the spindle out. This only moves it a millimeter or two at a time but it was enough with some penetrating fluid to get the spindle moving.
I had to take the disc cutter to the 850 I'm doing - even on the 40-ton press, it didn't want to move, despite the application of loads of penetrating fluid and heat!
It seems that the "spacer" or mushroom shaped adjustor is frozen to the shaft on my 850 commando.
Shaft spins easily, but for the life of me I can not get it to slide out. Any one have this happen? Advice?
It ALL has to come out. Throw it all away and install your adjustables. Make sure the rubber booties are closed right and as long as they aren't cracked, it will never happen again.
I had some other stuff I needed to order from them anyway, so I added it to the list and pulled the trigger.
Hope to get things moving in a more positive direction faster and sooner.
The Access Norton Website uses cookies to keep you logged in if you register.
By continuing to use www.accessnorton.com, you are consenting to our use of cookies.
