Pulled head and cylinder

O

okwebb

• Feb 3, 2021

• #1

So the valves are shot. Right piston rusted to cylinder. Need advice as to where to go to get work done on head, etc. Bottom end looks ok.
Thank you

 

Torontonian

• Feb 3, 2021

• #2

Lots of help in California. Good Luck.

 

texasSlick

• Feb 3, 2021

• #3

Best in the West ..... Jim Comstock, Comnoz on this Forum.

 

O

okwebb

• Feb 3, 2021

• #4

texasSlick said:

Best in the West ..... Jim Comstock, Comnoz on this Forum.

Click to expand...

How can I contact him? Where is he located?

 

Robert_Norton

• Feb 3, 2021

• #5

James Comstock

www.nortonmachineshop.com

That's his website, and he's located in Colorado. E-mail and phone number are on the website.

 

Last edited: Feb 3, 2021

Robert_Norton

• Feb 3, 2021

• #6

He (Jim Comstock) has shared a lot of technical information pertaining to Nortons here, too, which I have always found to be very interesting.


Okay, so this was supposed to be an edit to the previous post, not a new post.

 

Larry S

VIP MEMBER

• Feb 3, 2021

• #7

Did you or are you going to start a rebuild thread? That would be great.

 

C

cjandme

• Feb 3, 2021

• #8

Well worth the postage to send it to him.

 

grandpaul

VIP MEMBER

• Feb 4, 2021

• #9

Larry S said:

Did you or are you going to start a rebuild thread? That would be great.

Click to expand...

(To the tune of Devo...)

"Crack that Whip!"

 

milfordite

VIP MEMBER

• Feb 4, 2021

• #10

As long as you are in no hurry! He's had my stuff for over a year now.

 

lazyeye6

VIP MEMBER

• Feb 4, 2021

• #11

ENGINE DYNAMICS

ENGINE DYNAMICS, motorcycle performance, cylinder heads, performance kits

enginedynamics.com

located in Petaluma, CA.

 

ILLF8ED

• Feb 4, 2021

• #12

Keep it in California. Call Ken Armman in Campbell 408 626-0061.

 

MichaelB

"Sons of Arthritus"

VIP MEMBER

• Feb 4, 2021

• #13

California is a big State.
Where in Cali are you? North., South, Central?

 

O

okwebb

• Feb 4, 2021

• #14

MichaelB said:

California is a big State.
Where in Cali are you? North., South, Central?

Click to expand...

Sacramento

 

lazyeye6

VIP MEMBER

• Feb 4, 2021

• #15

you need a brit machine shop, not an intermediary.
Go with Jim Comstock or Engine Dynamics

 

Deckard

VIP MEMBER

• Feb 7, 2021

• #16

Ken Armman is probably less backlogged than Jim Comstock. I've utilized both with great results. Like milfordite, Jim's had my crankcase for several months now and seems to be too busy to answer correspondence lately.

 

D

drp

VIP MEMBER

• Feb 9, 2021

• #17

If you don't mind shipping charges you could try EV Engineering in Howard City Michigan https://www.shopevengineering.com