Pulled head and cylinder

Status
Not open for further replies.
Joined
Nov 20, 2020
Messages
59
Country flag
So the valves are shot. Right piston rusted to cylinder. Need advice as to where to go to get work done on head, etc. Bottom end looks ok.
Thank you
 
He (Jim Comstock) has shared a lot of technical information pertaining to Nortons here, too, which I have always found to be very interesting.


Okay, so this was supposed to be an edit to the previous post, not a new post.
 
Did you or are you going to start a rebuild thread? That would be great.
 
California is a big State.
Where in Cali are you? North., South, Central?
 
you need a brit machine shop, not an intermediary.
Go with Jim Comstock or Engine Dynamics
 
Ken Armman is probably less backlogged than Jim Comstock. I've utilized both with great results. Like milfordite, Jim's had my crankcase for several months now and seems to be too busy to answer correspondence lately.
 
Status
Not open for further replies.
Back
Top