Pre MK3 ignition switch cover
- Thread starter jimbo
- Start date
Tornado
VIP MEMBER
- Joined
- Dec 5, 2017
- Messages
- 5,257
Original. But they flop about and fall off. Not really sure the purpose. With a key in, flap is held open and rest of the cover becomes an air/rain scoop at speed.
- Joined
- Dec 8, 2011
- Messages
- 424
Jim,
That switch cover (p/n 06-4892) was apparently introduced when the Mark 1A started production. This switch cover works with a rear switch cover (p/n 06-4891). They continued to be used on later Mark II/IIa's.
Peter Firkins
johnm
VIP MEMBER
- Joined
- Feb 26, 2008
- Messages
- 1,992
Yes I beleive it's original on the later bikes but it looks rough and would more likely keep water in than out. I just cut it off straight away.
- Joined
- Nov 20, 2004
- Messages
- 21,090
Yes, introduced on the 850 Mk1A according to the Mk1A supplement but not according to AN which has a different original part number 06.4085 that makes no sense.
Andover Norton Parts Drawings - Andover Norton Factory Parts - Commando Parts
Andover Norton Parts are the only Norton spare parts in the market manufactured to original drawings, within the factory-approved tolerances, from the correct materials, and with the correct finish.
andover-norton.co.uk
Andover Norton - IGNITION SWITCH COVER (FRONT) - 06.4892
IGNITION SWITCH COVER (FRONT)
andover-norton.co.uk
