Nylon Oil Lines, Screws Interchangeable?

I have just finished making new 1/4" OD Nylon oil feed lines. In the process I mixed up the 3 banjo screws, left head, right side head, and lower feed. I marked them to
keep them straight, but forgot to look at the marks. Dummy! Now that they are all in place and tight, I noticed that I put the right hand dual-nipple screw down low on the lower feed banjo. It was a pain to install. If there is no difference, I'm done. But I want to be sure there will not be some obscure feeding problem due to a geometry or hole difference. To be clear, the banjos are all in the correct place, I just mixed up the screws. Any difference?
Thanks,
Jaydee

Parts blowup show all 3 the same part number. You should be just fine.

Did you use good copper washers on each side of the tubing fitting?

The steel banjo bolts screwing into the alloy engine parts and the relatively soft copper washers can make it difficult to feel the proper torque.