- Joined
- Dec 28, 2009
- Messages
- 5,159
Nice bearing but as posted before go roller for same price.
Torontonian said:Nice bearing but as posted before go roller for same price.
Shaft evidence shows the ball bearing shafts are NOT guaranteed to hold the shaft in place. How many times has anyone dismantled the box only to have the shaft come out in your hand and the bearing stays in the box :?:Onder said:...because no shimming required for the ball?
dynodave said:If you watch the NOC/Hemmings video he says 'the bearing is a slip/sliding fit on the shaft' .....functional quote only. This was discussed at the group viewing and critique of the video. So I'm not the only one :!:
L.A.B. said:dynodave said:If you watch the NOC/Hemmings video he says 'the bearing is a slip/sliding fit on the shaft' .....functional quote only. This was discussed at the group viewing and critique of the video. So I'm not the only one :!:
At what point in the video is Mick supposed to have said that? :?
dynodave said:L.A.B. said:dynodave said:If you watch the NOC/Hemmings video he says 'the bearing is a slip/sliding fit on the shaft' .....functional quote only. This was discussed at the group viewing and critique of the video. So I'm not the only one :!:
At what point in the video is Mick supposed to have said that? :?
I would have taken notes if I knew there was a quiz. :roll:
dynodave said:I watched it twice by myself, then a third time with the NENO group.
It must have been somewhere around the layshaft/bearing discussion. :lol:
IS it then that any lay shaft pulled that is securely a press fit to the bearing and the bearing comes out with the shaft is defective?
Testing against a whole pile of shafts (I own 23 gearboxes).
1. Some are definite press fit and a few are sliding.