Help with power-arc

Hey guys,
I'm just wrapping up the installation of the power-arc ignition and I have run into a snag. I have everything wired up, with the exception of the plug wires. The engine is set to TDC, and when I switch on the ignition and rotate the optical encoder disc, I cannot get the led light to come on. Are there any tips or tricks I am missing? I followed the directions to a T and have it wired as a positive ground. Any help would be greatly appreciated!

If you have a tester light check to make sure you really have power to the unit.
I just installed my Tri Spark the other day and had the same problem. Turn out I forgot to put the fuse back in.
Felt like a dope.

Guido said:

If you have a tester light check to make sure you really have power to the unit.
I just installed my Tri Spark the other day and had the same problem. Turn out I forgot to put the fuse back in.
Felt like a dope.

Click to expand...

That's exactly what it was. I pulled out my volt meter and found out the wire I thought was the ign kill switch was not. Had to trace it from the switch to the junction and hooked it up. Got it the bike static-timed and the encoder disc locked down. Thanks again for the help. Just needed to double check everything and not be an idiot!