- Joined
- Aug 5, 2017
- Messages
- 1,444

Hi all just gone to start assembly of the front Iso Vernier mount and have come up against an issue...
Mine is a 72 pre Mk3 and the AN kit ordered was 06-7337 which is labelled on the bag as correct
Assembled the bush tube into the mounting placed on both the stepped washers, PTFE washers, spun on fully the fixed nut & Vernier adjuster..... Only to find i have a large gaps between the components and the tube.
Measured the bush tube length against one removed, give or take a mm its spot on the same.
So am i anything missing from the kit .. i have:-
1x Bush tube
1x Fixed end nut
1x Vernier adjuster
2x PTFE washers
2x stepped washers
All that has been done to the mounting carrier is vapour blasted & sprayed with two pack
The overall length of the carrier is 105mm 4.13"
Mine is a 72 pre Mk3 and the AN kit ordered was 06-7337 which is labelled on the bag as correct
Assembled the bush tube into the mounting placed on both the stepped washers, PTFE washers, spun on fully the fixed nut & Vernier adjuster..... Only to find i have a large gaps between the components and the tube.
Measured the bush tube length against one removed, give or take a mm its spot on the same.
So am i anything missing from the kit .. i have:-
1x Bush tube
1x Fixed end nut
1x Vernier adjuster
2x PTFE washers
2x stepped washers
All that has been done to the mounting carrier is vapour blasted & sprayed with two pack
The overall length of the carrier is 105mm 4.13"