- Joined
- Oct 28, 2014
- Messages
- 1,869
I need a roll pin to hold the sprocket onto the points housing. I'm sure the local hardware store would have one if I knew the dimensions. I was hoping the AN parts page would give me the figures but no luck.
diameter and length, points housing roll pin
- Thread starter seattle##gs
- Start date
- Joined
- May 7, 2005
- Messages
- 6,819
Use pin gauges or a set of sized punches to see what the hole size is and a ruler to measure the length.
Amazon product ASIN B07QQWYGF5
Amazon product ASIN B07QQWYGF5
- Joined
- Nov 4, 2007
- Messages
- 1,362
DISTRIBUTOR SPROCKET SPRING ROLL PIN
CARBON STEEL ROLLED DISTRIBUTOR SPROCKET PIN, NOMINAL SIZE 3/4" x 7/32". FITS THE 033007 DISTRIBUTOR SPROCKET USED ON EARLY COMMANDO AND HYBRIDS.
www.rgmnorton.co.uk
is it that one , but better to check as Kommando said !
- Joined
- Nov 18, 2021
- Messages
- 24
Hardware stores are not what they used to be. Use a local bearing shop. they will even size the pin for you.
- Joined
- Oct 28, 2014
- Messages
- 1,869
That is it. I didn't think of RGM. ThanksDISTRIBUTOR SPROCKET SPRING ROLL PIN
CARBON STEEL ROLLED DISTRIBUTOR SPROCKET PIN, NOMINAL SIZE 3/4" x 7/32". FITS THE 033007 DISTRIBUTOR SPROCKET USED ON EARLY COMMANDO AND HYBRIDS.www.rgmnorton.co.uk
is it that one , but better to check as Kommando said !