- Joined
- Oct 28, 2014
- Messages
- 1,879
I need a roll pin to hold the sprocket onto the points housing. I'm sure the local hardware store would have one if I knew the dimensions. I was hoping the AN parts page would give me the figures but no luck.
Hardware stores are not what they used to be. Use a local bearing shop. they will even size the pin for you.I need a roll pin to hold the sprocket onto the points housing. I'm sure the local hardware store would have one if I knew the dimensions. I was hoping the AN parts page would give me the figures but no luck.
That is it. I didn't think of RGM. ThanksDISTRIBUTOR SPROCKET SPRING ROLL PIN
CARBON STEEL ROLLED DISTRIBUTOR SPROCKET PIN, NOMINAL SIZE 3/4" x 7/32". FITS THE 033007 DISTRIBUTOR SPROCKET USED ON EARLY COMMANDO AND HYBRIDS.www.rgmnorton.co.uk
is it that one , but better to check as Kommando said !