clutch stack height

My wrist was starting to complain about my clutch so I thought i would adjust the stack height,bronse plates,I got an old steel plate ground down untill 0.060'' thick, 0.080'' didn't fit, pull is much improved, but I now have mild slip in top gear,my question is how thin can the plate be made before it starts to distort,I realise that machining down a 750 pressure plate would be a much better idea. :idea: Has anbody fitted the ATLAS actuator :?:
ATF in primary and no gear oil on plates,was thinking of getting another 0.010'' ground off the plate but wonder if that will be enough :?:

Personally I wouldn't go less than .060 on any individual plate. I would leave the .060 extra plate in there and substitute a .070 for one of the other plates.

Has anbody fitted the ATLAS actuator

Click to expand...

My bike came with an old Dommie box and gears, covers etc except for the mainshaft. It took me a long time to find out why the clutch wasn't releasing fully. The Coil spring clutch actuator gives lots of leverage but 40-50 thou less travel from memory, enough to make neutral finding more difficult. Does give you one finger operation though!