907ie

katescottageiom

Joined
Dec 2, 2004
Messages
111
The hard steel fuel supply line insinde the fuel tank is pluged. I have tried air pressure up to 170 psi and various chemicals with no success. Tank has not been used since 2008. Anyone out there with an idea or two?
thanks,
jt
 
If I had a flexable bit I would, however the line has a two 90's at the top and one at the bottom. Thanks anyway. I tried a cable and a drill to no avail.
jt
 
Would that flexable curtain wire with the plastic cover stripped of fit through ?? rifleing rods or Pipe Cleaners .

WHAT mysterious Tube is This. Please Elaborate .
 
Matt, the fuel tank has a in the tank fuel pump and filter that connects to the fixed steel line inside the tank. The line drops down to the bottom of the tank takes a 90 degree turn, follows the bottom for about 8 inches and another 90 degree turn exiting through the tank to a short outlet of about 8mm o.d.
In the fall of 08 I had a r/r failure, the 4th failure by the way, and as I was using the 907 for daily transport for work I fired up the old Norton and bevel drive for transport until this particular work load was completed. The Norton and bevel are receiving some much needed service now and I would like to ride the 907 to the vintage races in Birmingham this fall
and visit a good friend up in N. Carolina before he goes back to Fla.
Any help will be most appriciated.
jt
 
I have the same tube on my Alazzurra. I don't think mine is clogged but I can see how it could get that way.

It'll be like cleaning out a sewer line only a LOT smaller.

907ie


I don't know if these are too big but it might work. You might need to clip the grabber arm part off, you just need the snaky part. Should be real cheap at Harbor Freight but check the diameter.
 
You must log in or register to reply here.
Back
Top