Four different covers? I have only seen one design and two different mounts. The P11 with a rather straight front edge and only one hole in the top, where the P11A and Ranger has an extra hole in the rear for an extra fastener. The P11A and Ranger cover also has a slight relief at the front for clearance of the ignition switch mount.As far as i know there was 4 different battery covers model and 2 different ways to fasten them to the frame.
I would like to see some pictures of the early P11 battery side cover.
Thank you.
Piero
Four different covers? I have only seen one design and two different mounts. The P11 with a rather straight front edge and only one hole in the top, where the P11A and Ranger has an extra hole in the rear for an extra fastener. The P11A and Ranger cover also has a slight relief at the front for clearance of the ignition switch mount.
The only part number I have ever seen is in the '66-'66-'67 parts book, (P/ N 034075) which lists it for both P11 and P11A!
The cover shown in early P11 advertising was airbrushed in and never actually produced.
Has this burtonbikebits cover been compared to OEM?