Finally installing the new switch cluster & Master cylinder I got from CNW. According to the books wire diagram There is a white/yellow wire in the (L/H) switch that goes to a connector, from there it's a blue/white wire that used to go to the Ballast Resister. I have a Boyer MIIII ignition so now that (B/W) wire goes to the white from the Boyer box. My new switch does not have a "kill switch" so I was just going to disconnect the (W/Y) from the old Lucas switch & just not have a kill switch but will this disconnect power to the Boyer?? And if so can I just run the white from the Boyer to a white triggered from the ignition (key) switch??