Wiring at Coil, Capacitor/Condenser?

I am putting a single coil on. How do I wire the capacitor in with a TriSpark? The OEM cap has a connection for each coil, is runny and gooey and looks like it is bad. Now that I have a single coil, does it have to be replaced with a single cap? If so, what should I use. Confused again by wiring!
Thanks, Jaydee

The original points ignition capacitors/condensers should be completely disconnected when an electronic ignition system is fitted.


http://www.trispark.com.au/images/Class ... 202013.pdf

Disconnect and remove the condensers and do not reconnect them
to the electrical system - they are not required with electronic ignition.

Click to expand...

Thank you so much. I apologize for not reading the instructions closely.
Jaydee

Yep Sir, real men don't ask directions nor read instructions ... til all else fails. I know your mostly lazy but rather smart kind, so of course easier to ask here than hunt through and focus on a manual, which often as not in our stuff is not the way to do it. Do start at night and jiggle wiggle and blip for some clues if all is well. May your Positive Earths stay conductive smoke tight.