Thickness of gearbox cradle plates.

Hi making some spacers to fill in the gearbox adjustment slot. Belt drive. Does anyone know the thickness of the cradle.
Thanks Chris

I believe those plates are 1/4" thick, according to my design drawings for the "big bearing" conversion. However, I'm taking that from the outer dimension plate-to-plate, minus the inner dimension that i DID show on the drawing. I didn't specifically indicate the plate thickness since that was not a variable in the conversion.

I just put a digital caliper across mine and it came out at 0.28” so a fraction bigger than 1/4”

Thank you. I can cut them. Out now.

.03"... about the thickness of factory paint?