- Joined
- Oct 28, 2014
- Messages
- 1,873
I have two premier Amals that took "forever" to tickle. After 24 hours of non use I could count to thirty before they would lightly overflow. My solution was to use a short piece of 1/16" rod (I used the back end of a drill bit), tapered one end slightly and pushed it up the center of the roll pin. I used a small c-clamp for the job. If a straight edge is used on the bottom side of the carb the pin is just short of the straight edge. There is no chance of it falling out and it now floods in 5 seconds.