Resistor Caps vs Plugs
- Thread starter bpatton
- Start date
- Status
Sure, plenty of them. Go to http://www.sparkplugs.com (for example) and you can find a cross-application chart. I use Denso IW-22s (fine-wire iridium) myself but anything that cross-references (to NGK BP7ES) will work.
cash said:
Sparx said the same thing in response to my question about their three-phase alternator (which also requires 5K ohms resistance). Seeing's how it's getting difficult to find NON-resistor plugs (sure, there are still some, like NKG's BP7ES, a fine plug, but the selection is limited), I run low-resistance wires and resistor plugs.
illf8ed said:
Generally digital electronic ignitions can need 5,000 Ohms suppression to protect the microprocessors from interference.
http://en.wikipedia.org/wiki/Electromag ... terference
Therefore digital ignition systems such as Boyer Micro Digital, Micro Power, Tri-Spark, Pazon Smart Fire all require suppressed plugs or caps to be fitted.
Analog/analogue systems such as Boyer Bransden Micro MkIII, Lucas Rita, etc. are not affected, so do not require suppressed caps or plugs although it is often a good idea to fit them to stop TV and radio interference which is why they were fitted in the first place.
maylar
VIP MEMBER
JimC said:
I'm using resistor wires on my bike now. It's just an experiment, as I needed to make up new wires and that's all I had. Some people claim that the vibration of a Norton will cause the carbon in resistance wires to eventually separate and lose conductivity, so plugs or caps are preferred.
From what I understand, SCR regulators (like the Sparx 3-phase) are prone to triggering by RF interference and can over charge your battery. My regulator is a long way from the spark plugs and I never had any problems with solid wires.
- Status
