Replacement Speedo

ntst8

VIP MEMBER
Joined
Feb 14, 2004
Messages
1,791
Country flag
I am looking for a replacement speedo for my 961, it works except for the backlight so is invisible at night.
Does anyone have experience or thoughts on the Smiths one linked below?

http://www.puca.co/productled.html

Have also seen Motogadget but they are a bit pricey.
 
Good question, i hadn't give the original supplier a thought as the factory ones seem a bit cheap plasticy.
Will check them out though.
 
I am looking for a replacement speedo for my 961, it works except for the backlight so is invisible at night.
Does anyone have experience or thoughts on the Smiths one linked below?

http://www.puca.co/productled.html

Have also seen Motogadget but they are a bit pricey.

I had the same problem. Spoke with Rob Jameson and he informed me it was a sealed unit so would have to be changed. Asked for that recently under warantee and someone there then realised that I had probably lowered the illumination level myself by pressing the button in the wrong sequence. It was probably when I tried to reset the time and I was just pressing and holding and hadn't a clue. page 113-114 in the small booklet is where you should find your answwer so I was told. Mine is fine now

Just looked at the book but not very clear but guessing you just scroll through options and illumination comes up ( i recall Marie from service saying).
 
Last edited:
Thanks I’ll check that out. That sort of unintended technical excellence is right up my alley.
 
Congratulations to Welshrugby, i had the same feedback from Rob J so hadn't investigated further.
Just had a play and if you turn the key on then hold the toggle switch down for a couple of seconds ILL shows up, then short prods on the button scrolls through 0 - 9. At 5 hey presto i have a speedo backlight again. I like a cheap fix.

If by small book you mean the Owners Handbook, pages 113 and 114 in mine are blank. I guess they added to it over time.
 
I have had look on the VDO website for a data sheet, found one with what looks to be the right functions but is for a different unit.
Have now left a note on their contact page, will post here if they get back with anything useful.
 
Back
Top