Premier float level

Status
Not open for further replies.
R

Ratboiler

Joined
Apr 4, 2020
Messages
60
Country flag
Just a quick question.
I have the AN kit to test the float heights which recommends a fuel height below the top edge of the float bowl as 6mm lowest 4.3mm highest.
The left side falls within this as soon as the fuel is turned on, the right side is 10mm below the top edge of the fuel bowl.
If I then push the ticker and flood the carb, the fuel level settles within spec when I stop flooding it.
Any suggestions please?
I have clipped the kit into position and start the bike after the weekend (her indoors).
 
Sounds like you could have a sticky float needle or float pivot, as suggested with the AN kit how does the level sit with the engine running?
Might be worth dropping off the float chamber to inspect the needle
 
Sounds like something in there is inhibiting free movement. As Malcolm suggests, best drop the float bowl and inspect. May be crud or corrosion around the needle, or the gasket may be inhibiting the float or the float pin itself. Not a big task......
 
Status
Not open for further replies.

Similar threads

concours
Amal Premier float crack
Replies
10
Views
399
concours
concours
S
setting float levels
Replies
4
Views
609
Triton Thrasher
Triton Thrasher
T
Premier concentrics fuel level from factory.
2
Replies
28
Views
1,365
black cat
black cat
Tinkerbell
  • Locked
Amal Premier Float Test with Fuel on Jig--Way High!
2
Replies
27
Views
4,637
holtcorseaux
holtcorseaux
Gadge
  • Locked
Amal Premier - Casting Porosity?
2
Replies
23
Views
2,119
L.A.B.
L.A.B.
Back
Top