New spindle bushes and spindle 74' Commando

Jonez69

Jonez69

VIP MEMBER
Joined
Aug 15, 2024
Messages
112
Country flag
Once installed, my new spindle bushes have compressed enough to not allow easy fitment of the spindle. What is my best course of action? Is it okay to use 1000 grit wet/dry to size the bushes to the spindle or will I compromise the bush porosity and hinder proper lubrication? I am also installing the Kegler clamps. The new spindle is machined for them which was a nice surprise! Thanks for your replies !
PS- I definitely needed a new spindle.....
New spindle bushes and spindle 74' Commando
 
Will the spindle slip fit in each bushing from both sides as they are installed in the swingarm? If yes, and the spindle won't slip through, they are out of line and should be line reamed. Sanding will likely clog the pores. Reaming is better. Oversize spindles might be available for your model if needed
 
Last edited:
It has to be a very sharp reamer or it smears the bronze instead of cutting it, plus needing to cut it to a size to suit the shaft means an adjustable reamer is best but that also smears rather than cuts in bronze. I would go for a flexible honing reamer and then wash religiously.


New spindle bushes and spindle 74' Commando
 

Similar threads

T
  • Locked
'74 Commando Alternator Rotor
Replies
13
Views
1,944
thunderbolt
T
nortriubuell
  • Locked
Swingarm spindle conundrum (2020)
Replies
10
Views
2,712
marshg246
marshg246
M
  • Locked
74 Commando Boyer Testing
2 3
Replies
49
Views
7,271
MarkDeaton
M
J
'74 Commando 850 refurb
2 3
Replies
40
Views
8,584
Saber
Saber
joe czech
  • Locked
noob, first post, and my 74 commando project
Replies
10
Views
2,046
JimC
J
Back
Top