N15 head issues

Joined
May 12, 2018
Messages
91
Country flag
As I was timing my bike the other day, my hand brushed against the rear of the cylinder. I then heard a “tink” noise. First reaction was, “Oh $#!+, don’t be the rear head bolt stud!” Sure enough. It’s stripped out.

In my research, I’ve found Jim Comstock and Memphis Motor Werks. Anyone else out there who does quality service that I should check with? Turn around time ranks a bit higher right now than $200-$300 difference in price. I’m going to have the whole head redone on top of thread inserts installed; new valves, guides, etc..
 
Jim Comstock did my head, and I would whole heartedly recommend him. If turn around over-rides him, then I would check out Big D Cycles in Dallas TX.

Slick
 
Back
Top