1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

N15 head issues

Discussion in 'Other Norton Motorcycles' started by Paul W., Mar 24, 2019.

  1. Paul W.

    Paul W.

    Joined:
    May 12, 2018
    As I was timing my bike the other day, my hand brushed against the rear of the cylinder. I then heard a “tink” noise. First reaction was, “Oh $#!+, don’t be the rear head bolt stud!” Sure enough. It’s stripped out.

    In my research, I’ve found Jim Comstock and Memphis Motor Werks. Anyone else out there who does quality service that I should check with? Turn around time ranks a bit higher right now than $200-$300 difference in price. I’m going to have the whole head redone on top of thread inserts installed; new valves, guides, etc..
     
  2. texasSlick

    texasSlick VIP MEMBER

    Joined:
    Jan 2, 2013
    Jim Comstock did my head, and I would whole heartedly recommend him. If turn around over-rides him, then I would check out Big D Cycles in Dallas TX.

    Slick
     

Share This Page