- Joined
- Feb 9, 2009
- Messages
- 913
I am confused about my Ignition Switch. The bike was fired up by the PO when I bought it, ran ok. I am cleaning, rebuilding, replacing. and LEARNING.
The ignition switch wiring looks different than the schematic. There is a ridge on the top of the switch, which I have shown on my sloppy diagram.
1...When you look at the schematic, I assume you are looking at the back of switch. Correct?
2...The back of my switch is wired differently than the schematic shows. White and Brown/Green are swiped. Which way should I wire it?
3...I don't feel ready to completly rewire right now; I want to get this thing on the road in the spring. Can I clean the blade terminals with Acetone and reassemble?
The ignition switch wiring looks different than the schematic. There is a ridge on the top of the switch, which I have shown on my sloppy diagram.
1...When you look at the schematic, I assume you are looking at the back of switch. Correct?
2...The back of my switch is wired differently than the schematic shows. White and Brown/Green are swiped. Which way should I wire it?
3...I don't feel ready to completly rewire right now; I want to get this thing on the road in the spring. Can I clean the blade terminals with Acetone and reassemble?