Hi,
I am trying to adjust Amals 932 on my Combat Commando. I did everything acc. Bushman's carb tuning, but on my bike it works only with choke.. When I try to pull up the choke sliders during idle, it immediately cutting out..
When the choke slides are down, idle is good. When I'm holding the engine on higher rpms by twist grip without choke, it running well. Yesterday I ran the bike few km (to be sure that engine is warm enough), everytime when I stop on lights - I had to turn on the choke!
I tryed to adjust air screws again, but it causes misfires (screw out) or not running (screw in). Adjusting throttle sliders had no influence..
I am wondering if KN filter or reed valve (from Yamaha XS650) could have influence...
Do anybody has experience with same/similar problem? Or I am doing something wrong?
Thanks for any advice..
I am trying to adjust Amals 932 on my Combat Commando. I did everything acc. Bushman's carb tuning, but on my bike it works only with choke.. When I try to pull up the choke sliders during idle, it immediately cutting out..
When the choke slides are down, idle is good. When I'm holding the engine on higher rpms by twist grip without choke, it running well. Yesterday I ran the bike few km (to be sure that engine is warm enough), everytime when I stop on lights - I had to turn on the choke!
I tryed to adjust air screws again, but it causes misfires (screw out) or not running (screw in). Adjusting throttle sliders had no influence..
I am wondering if KN filter or reed valve (from Yamaha XS650) could have influence...
Do anybody has experience with same/similar problem? Or I am doing something wrong?
Thanks for any advice..