Hammer drive screws

Status
Not open for further replies.

Commando75

Joined
Aug 25, 2008
Messages
134
I am getting down to the little parts now. Can anyone advise a source for the hammer drive screws to mount a data plate? I see they are available but I have not been able to pin down a source that I can order them from. Also, what size are these babies? Seems like the little things can be the biggest pain in the seat warmer. Any help would be greatly appreciated 8)
 
I have 1/8 inch and 3/16 inch drive screws in my kit. The ones I used were 1/8 inch. I have a few spares and I'm happy to send you 4 if you are stuck. PM me an address if you're interested.
Greg
 
Old Britts has them and they are close to you, you could also try Rabers.

Dave
69S
 
Thanks everybody. I will call Old Britts in the morning. If that doesn't pan out I will check the other sources. I thought I was just going to walk into the local hardware store for these but such was not the case. Thanks again. This forum is amazing.
 
Status
Not open for further replies.
Back
Top