Just balanced my commando amals with a morgan carbtune. Did as the manual said, balanced them to a high tickover rate of 1500-1800rpm on the throttle not the throttle stops.Lowered the left to equal the right. All set up fine until I blipped the throttle. This saw the level on the left decrease slightly but the right side increase!
Is this normal , or should both increase in proportion to the throttle position.
Other than that everything runs ok.
All the connections were correct and free from kinks.
It does have a slightly less compression ratio on the left, but nothing drastic.
Not used these before, always done it by wire under the slide which works ok if all else is fine.
any tips welcome
thanks
chris r
Is this normal , or should both increase in proportion to the throttle position.
Other than that everything runs ok.
All the connections were correct and free from kinks.
It does have a slightly less compression ratio on the left, but nothing drastic.
Not used these before, always done it by wire under the slide which works ok if all else is fine.
any tips welcome
thanks
chris r