Air Horn Install

napanorton · Sep 22, 2012

My stock horn died - no surprise there. So I decided to attempt an air horn. I used a Stebel Nautilus Compact Airhorn - which have been mentioned here before. My twist was to try to get at least some of it in the stock location. Here's my post on the adventure. http://www.doov.com/apps/nortoncomp...ticle&id=38:air-horn-upgrade&catid=1&Itemid=8 Hope it's somewhat interesting...

ntst8 · Sep 22, 2012

compliments on the installation and on your website.

swooshdave · Sep 22, 2012

napanorton said:
My stock horn died - no surprise there. So I decided to attempt an air horn. I used a Stebel Nautilus Compact Airhorn - which have been mentioned here before. My twist was to try to get at least some of it in the stock location. Here's my post on the adventure. http://www.doov.com/apps/nortoncomp...ticle&id=38:air-horn-upgrade&catid=1&Itemid=8 Hope it's somewhat interesting...

That 3D printer is cool. How do you think the plastic will hold up to the vibrations?

napanorton · Sep 22, 2012

Yes, the horn body is very lightweight, so the forces should be low. Also the superglue I used to bond it is pretty stout. I guess time will tell.

Air Horn Install

napanorton

ntst8

swooshdave

napanorton

Similar threads