72 Dunstall Norton 810....isolastics

Hi all.

Recently got my hands on my fathers '72 Dunstall Norton. http://www.dunstallnorton.blogspot.com and am going through the process of bringing the bike back into proper running condition. I'm optimistic thusfar, as the old girl has less than 5,000 miles and the Dunstall 810 alloy cylinder is tucked away in a box on my shelf instead of actually on the bike causing problems.

An important goal of mine is to replace the isloastic mounts on the bike. My question to you folks is, where is the best source for the bits and pieces required?

Any advice is appreciated. I'm sure this has been covered in the forum at some time in the past so an appropriate link will suffice as well.

If you're looking for a west coast source...two are good.
www.fairsparesamerica.com Phil Radford
www.rabers.com Bob Raber

http://www.ebay.com/itm/Norton-Commando ... 0b&vxp=mtr
http://www.ebay.com/itm/Norton-Commando ... f8&vxp=mtr

illf8ed said:

If you're looking for a west coast source...two are good.
http://www.fairsparesamerica.com Phil Radford
http://www.rabers.com Bob Raber

Click to expand...

Really? I'd send him to Old Britts in a second. To Portland you usually have it by the time you hang up the phone!

Welcome and please come down to the Oregon Norton Enthusiasts club meeting on April 6th. Can't wait to meet you!

http://oregonnorton.org

Thanks for the advice guys. Much appreciated.

Dave, thank you for the invite. I hope to be moving into my new house on April 6th but I will absolutely show up in May.