'70 Clutch Lever Assembly (06-0691)

Does anyone know of a source that might have the entire clutch lever assembly available? My 70 has a 73 disk brake front end on it and the PO put the 73 switchgear on the clutch side as well. I want to go back to the Ducon switch and original type perch/lever on the clutch side, but cannot seem to locate a vendor that has the complete assembly available. I don't necessarily want to go too far aftermarket as I want to make sure that I get the 7/8" center to center spacing correct. If there is something else out there that I can use, any suggestions or advice would be greatly appreciated. I'm not necessarily concerned about 100% original, but want to get something that works and isn't going to mess with clutch leverage. I have searched and searched the forums, but am just looking for a source for either the original assembly, or something that has the necessary dimensions.

Thanks in advance.

I recently got the body, 06.0062, from DomiRacer. They had the strap too. Don't know if they have the complete assembly, but may be worth a try. I got a lever, 18752, from Walridge quite a while ago, he may still have some, you might even try Mike for the whole assembly. They are hard to come by complete, but I have put my old sets together from parts I got from Walridge, DomiRacer and British Only in MI.

You may have to get it in parts.

Dave
69S

chapmanmd said:

I want to go back to the Ducon switch

Click to expand...

The original Commando switch unit was the "Triconsul" (Hi/Lo beam, horn, headlamp flash) not "Ducon" (or "Tricon") however pattern Triconsul switches are not available as far as I know.

06-0691 is still listed so presumably it's still available as a genuine AN part.

060691 = http://www.nortonmotors.de/ANIL/Norton% ... mit=Search

Mark, give Ron L a PM or email, he has a lot of the early Triconsul parts.

Dave
69S

Thanks guys. I ordered the part number from AN. Now let's see if I get just the lever or the entire assembly as noted in the Spares Guide.