3-phase question

speirmoor · 2025-12-05T08:53:45-0700

JimNH said:
I used to stuff hand warmers in my gloves and boots, even in my pockets. I still use them in work gloves when working outside in the cold. The 7 volt stuff is probably useful for its portability. My loader's 60 amp alternator was hardly working. Yeah, they're a little too much for the bike now but LEDs will free up the amperage I need.
I wonder how the police bikes handled tube radios, emergency lights and siren?

What LEDs are you using? I need to get some if you have a link

kommando · 2025-12-05T09:13:13-0700

But what is in the plastic bag to warm it up. Best not answered :}

concours · 2025-12-05T09:30:00-0700

Great products, great service:

http://www.norbsa02.freeuk.com/goffyleds.htm

If you are converted to negative earth, these are the stuff:

H4 LED Headlight Bulb | Motorcycle Lights | Brightest h4 LED Bulbs

www.cyclopsadventuresports.com

bill · 2025-12-05T09:53:42-0700

You can rewire the headlight hi low switch and use a negative ground led bulb. Not a big deal

Elfix · 2025-12-05T11:13:49-0700

On my G15 I have added a higher output stator and solid state regulator/rectifier. With a led headlamp there is plenty of juice left over to heat the heated handgrips I’ve installed.

I’ve taken to wearing a Alpinestars airbag vest which is warm enough to have reduced my need for the electric vest….. but I can’t seem to get on without the heated grips.

hhh · 2025-12-05T12:19:39-0700

Note that the original rectifiers and regulators were solid state.

concours · 2025-12-05T13:00:18-0700

hhh said:
Note that the original rectifiers and regulators were solid state.

Good point...

3-phase question

Similar threads