- Joined
- Dec 5, 2010
- Messages
- 18
Hi - today i started a small repair job to replace the swing arm bushes on my 1969 Commando however to my surprise i found that the centre shaft is not threaded (normally 1/2')
is this something normal for a pre-1970 commando?
Any suggestions regarding getting the shaft out would be much appreciated - while it is in the frame with access from one side only
many thanks
is this something normal for a pre-1970 commando?
Any suggestions regarding getting the shaft out would be much appreciated - while it is in the frame with access from one side only
many thanks