Fork Re-chroming

Joined
Dec 6, 2012
Messages
93
Country flag
I need to get my N15 fork tubes re-chromed, can’t find any new ones
Any recommendations, based in UK
Thanks Richard
 
AM Philpot in Luton. Highly regarded, and I called in recently about something else, all looked good.
Thanks for that, remember using them years ago but thought they went through a “rough” time but looks like ok now …… thanks
 
I had five pair of new Rickman stanchions done & a pair of 34.5 mms Trident forks built up to 35mm for North yokes & clipons & they did an amazing job​
 
I've used the above & also Nottingham Hard Chrome & Grinding. Also very good.
 
I've had two sets done by philpots
One pair were really good
One pair were ok from memory
 
Thanks for all replies, anyone used or heard any reports of Brook Suspension ?
 
Last edited:
Not sure which diameter fork tubes it takes. I just replaced the ones on my '61 Matchless G3 which may be the same.. I had a hard time finding them but finally did at Walridge Motors. Quality was excellent. I think the price for polishing/rechroming would be close to what a new set of fork tubes would cost.
Russ
 
Thanks for info, now I have a dilemma, new ones or re-chrome ? Both options are the same price
 
Thanks for info, now I have a dilemma, new ones or re-chrome ? Both options are the same price
Corrosion without pitting is rare. If your fork tubes are just mildly pitted in the region swept by slider's upper bearing bush, I'd choose rechroming ("hard chroming").
Be sure to obtain a cost estimate before embarking on this route, and make sure your fork tubes are absolutely straight (perform the rolling test on a flat surface).

There are a few pitfalls associated re-chroming.
https://hcsplating.com/resources/hard-chrome-plating-guide/common-problems/

If fork tubes show noticeable pitting to a depth which requires grinding them, quality fork tubes as offered by AN would be my preferred alternative.

- Knut
 
Last edited:
Corrosion without pitting is rare. If your fork tubes are just mildly pitted in the region swept by slider's upper bearing bush, I'd choose rechroming ("hard chroming").
Be sure to obtain a cost estimate before embarking on this route, and make sure your fork tubes are absolutely straight (perform the rolling test on a flat surface).

There are a few pitfalls associated re-chroming.
https://hcsplating.com/resources/hard-chrome-plating-guide/common-problems/

If fork tubes show noticeable pitting to a depth which requires grinding them, quality fork tubes as offered by AN would be my preferred alternative.

- Knut
Thanks again
 
Back
Top