- Joined
- Aug 1, 2011
- Messages
- 475
Bought a new set of handlebars, they were the proper height, pullback etc and they are an exact match for the former ones except the new ones were not bent. The issue is that the throttle twist housing does not clamp down on the bars completely. They are loose enough to slide off. The switch clusters tighten up just fine. I am assuming the bars are a bit smaller in diameter that the originals. Looking for suggestions to fill the gap. As a temp solution, I had put a piece of duct tape around the bars at the clamping point. Worked well until it got hot out.