Stainless Iso End Caps, Where to buy?

Status
Not open for further replies.
G

GRM 450

Joined
Dec 30, 2008
Messages
985
Country flag
Hello, would some one please advise me where to buy stainless end caps for Isolastics.
The front original # is 06-5525, the rear original # is 06-5526.
I added the original part numbers incase they are called something else. (the bit the ptfe thrust washer sits against)
Thanks, Graeme.
 
Graeme,

Have a look at the RGM and Norvil web sites they should be a bit more affordable.

Cash
 
Unless they're all rotted out the old ones can be cleaned up and reused. They hide behind the gaiters and can't be seen anyway. Smear them in siicone grease for protection.
 
Thank you gents, $600 is too much for me. I already have the iso's and abutments in stainless from NZ at a fraction of $600.
Maylar's advice of using standard and coating with rubber grease, as they're not seen, is a good idea.
I'll buy new standard items as the old ones are badly rusted.
Thanks again,
Graeme
 
Mick Hemmings sells them in SS too I believe.

$600 is a lot. I checked out CNW's site and for that $600 you get everything as well as a polish job on the SS parts. That price is assembled into the iso tubes as well I believe. You can save a lot of cash by doing the polishing and assembly yourself.
 
Status
Not open for further replies.
Back
Top