Removing old gasket material

Status
Not open for further replies.
DogT

DogT

VIP MEMBER
Joined
Jan 20, 2009
Messages
7,394
Country flag
I removed the retaining plates for the rocker shafts to polish and plate, and the inside plate seems to have the gaskets glued to them. Is there any way I can soak these gaskets off? It is pretty dangerous with a knife and the fingers because they are so small. Also, what sealant should I use to put the gaskets back on?

Removing old gasket material

Dave
69 'S' project
 
Another option is a good soak in carb cleaner. Drop them in the bucket and let them soak for an hour or so. Usually works pretty good for me.

Debby
 
Power wire brush. Watch your fingers! I use Permatex Aviation Gasket (non setting) Sealant. The brown goo.

Mick
 
I soaked them in some engine degreaser I had laying around and that softened them up good enough to rub them off. Looks like most anything will work that has some petroleum in it.

Dave
 
Thanks all. I ended up using a wire brush in a Dremel tool. Worked a treat. Resealed with "Yamabond," which I swear by.
 
Status
Not open for further replies.
Back
Top