Protocol to cold weld races in worn bores

Status
Not open for further replies.
Heres my gearbox fix

Protocol to cold weld races in worn bores
 
Dances with Shrapnel said:
What was broken on the gearbox that you fixed?

The web between the bearings was cracked and both bores were too loose, not really bad but a good tap with a mallet and both would drop out without heating the case. The cap screw doesnt actually bottom out on the bearing races (very close though) so it will prevent them from rotating and or walking out of the bores. The Devcon seemed like a good idea at the time, it cant hurt anyway.
 
dont mention I said so , but somebody says J B Weld is bloody Tough . If you dont mention my name & dont tell who told me . :x 8) some darn aerospace two pot head proof goop , can glue silencers together with it , & alledgedly Tap it for Freds .

:shock: :|
 
Status
Not open for further replies.
Back
Top