N15 Spacers in frame.

Are spacers required between the frame and the support engine plates (and between the engine plates) where the long square stud goes through that you attach the brackets to that the riders foot pegs attach to. My bike was in bits there are none around but I though that they would be needed to add support to the engine.
Cheers,
Monaro.

There are three spacers on that rod
010911 - fits between foot peg and right engine plate
030236 - fits between foot peg and left engine plate
030237 - fits between engine plates

I only have the size for the left side 5/8 ID, 7/8 OD, 3/4 thick.

Its a real PITA to get everything lined up. Once in place though, you shouldn't have to touch it again. There's a way to install/remove the outer primary with the foot peg in place (fit over the rotor oriented vertically, then rotate into position as you slide it into place) :wink:

Thanks Bill,
If I cant find them, then at least I can fabricate them. The primary is off the bike.
Cheers mate,
Monaro