mikuni jetting 750 single

Ok looking for a good starting point for jetting a single mikuni vm34 on a 71 750 commando with currnetly point and if funds alow a old britts new electronic ignition .
looks like ive found as follows but would like input
main 220
needle jet 159 p2
needle 6HD3
pilot jet 35
slide #3
air jet 2.0
whats your setting??????????

One of the more common setups and no one has any input on a starting point?

OK here's where I'm at-

Pilot Jet-----------30
Slide size---------3.0
Needle jet-------159 IPO
needle-----------6DH3
Needle clip------2nd groove from top
Main jet---------240
Air jet-----------2.0

Works for me. The only issue I have is plugs tend to load up if I don't get it off of choke quick enough when it's cold.

tjfisher said:

One of the more common setups and no one has any input on a starting point?

Click to expand...

These are both in the ball park and are good starting points. tjfisher, I would go with the numbers you have for I believe that is what you will get if purchased from RockyPoint, other than possibly a larger main.

You can really go big on the main jet. I went up to and beyond a 300, but found the best balance around 260, but i have a Combat spec 750. I also was running the 36vm rather than the 34vm. Again, this was due to the Combat specs and an 1 1/2 exhaust.
You will love the 34vm.

Thanks guys I know that each one is going to run just a little different and will always need tweeking but that's the nature of our bikes if you want perfect don't have a love for old British bikes . Thanks for the input !!!!!!!!!